Aqua Mix Sealer’s Choice® Gold Rapid Cure Formula

Product Description

Aqua Mix Sealer’s Choice® Gold Rapid Cure Formula 13261 is a premium, no-sheen, natural-look, Low VOC, water-based, penetrating sealer formulated to

pprovide maximum stain protection, especially in food preparation and serving areas. May also be used as a pre-grouting sealer. Aqua Mix Build Green, Low VOC (Volatile Organic Compound) formulas helps to provide better indoor and outdoor air quality compared to similar traditional products. This product Complies with EPA and CARB VOC Requirements.

KEY FEATURES

• May be used as a pre-grouting sealer • Allows moisture vapor transmission • The NEW Rapid Cure Formula protects in less than 4 hours • Designed to achieve optimal penetration into dense, low-porosity surfaces AREAS OF USE • All porous tile and natural stone (such as marble, granite, slate, travertine and limestone), porcelain, quarry, Saltillo, terra cotta, cement pavers, masonry surfaces, and other porous tile and grout where a natural look is desired • Effective for interior and exterior applications LIMITATIONS • Do not allow sealer to come in contact with any non-recommended surface • May slightly lighten or darken some surfaces • Sealer will not prevent surface wear or etching from acids or caustic chemicals

METHODS

Application Read entire label before using. For new installations, sealer can be applied as soon as 48 hours after grouting. Surface must be clean, dry, and free of existing sealers or coatings. Apply using a sponge, brush, paint pad, cotton towel, or sprayer. NOTE: Be sure any sealer that does not penetrate surface is removed from surface within 5 minutes of each application using absorbent paper or cotton towels. If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats. 2 hours after final coat conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test. Ready for surface traffic in 2 hours after final coat. Keep area dry for 12 hours. Achieves a full cure in 24 hours. Clean applicator tools with water after each use.