Aqua Mix Penetrating Sealer-1 gal.

Product Description
Aqua Mix Penetrating Sealer is an economical, no-sheen, natural-look, water-based, penetrating sealer designed to resist stains. May also be used as a pre-grouting sealer.
Aqua Mix Build Green, Low VOC (Volatile Organic Compound) formulas help to provide better indoor and outdoor air quality compared to similar traditional products. This product Complies with EPA and CARB VOC Requirements.

KEY FEATURES - Allows moisture vapor transmission • Can be used as a grout sealer

AREAS OF USE - All natural stone (such as granite, limestone, marble, slate, and travertine.), porcelain, quarry, Saltillo, terra cotta, cement pavers, masonry surfaces • Other porous tile and grout where a natural look is desired • Effective for interior and exterior applications

LIMITATIONS - Do not allow the product to come in contact with any non-recommended surface • If the product is allowed to dry on the surface, a white film may form • If this occurs, scrub the surface with water and a white nylon pad • Sealer will not prevent surface wear or etching from acids or caustic chemicals •

Note: Aqua Mix Ultra-SolvTM or Sealer’s ChoiceTM Gold are recommended in place of Penetrating Sealer in food preparation areas or where maximum stain protection is required.

Installation: METHODS Application Read the entire label before using. For new installations, sealer can be applied as soon as 48 hours after grouting. The surface must be clean, dry, and free of existing sealers or coatings. Apply using a sponge, brush, paint pad, cotton towel, or sprayer.

NOTE: Be sure any sealer that does not penetrate the surface is polished and dry off the surface within 5 minutes of each application using absorbent paper or cotton towels. If 2 or more coats are applied, allow a minimum of 30 minutes of drying time between coats. 2 hours after the final coat conduct a test to determine if the surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test. Ready for surface traffic in 2 hours after final coat. Keep the area dry for at least 12 hours. Achieves a full cure in 24 hours. Clean applicator tools with water after each use. For Pre-Grouting Application Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above